12
English
WARNING:
To avoid risk of fire, electrical shock, or injury to persons, unplug
the Air Circulator before removing the grill.
Tip:
To prevent scratching, gently cover the tip of a flat screwdriver with a
soft cloth.
Place flat screwdriver against the angled section of the grill support tab,
(as shown) and press outward to allow the grill wire to be released from the
support tab. Repeat on second and third grill support tab. To reinstall, relocate
grill wire ends into the support tabs, use the flat screwdriver to flex back the
support tabs to allow grill to snap into place. Be sure all three grill wire ends
are engaged.
GRILL REMOVAL
BLADE REMOVAL
WARNING:
To avoid risk of fire, electrical shock, or injury to persons, make sure
the Air Circulator is still unplugged before removing the blade.
It is possible to remove the blade should something accidentally get wrapped
around the motor shaft.
VFAN JR:
Remove the Blade Cap by wedging
a cloth wrapped screwdriver under the Blade
Cap. Next, remove the Nut by rotating clock-
wise and then remove the Washer. Pull the fan
blade straight out from the shaft (Fig. 1). When
replacing, the Blade can only go on the shaft
one way. Push the Blade all the way on the shaft
until it bottoms out. Do not use a hammer as
this could result in bearing damage. Replace
the Washer, the Nut, and then just press the
Blade Cap in place to secure.
VFAN, VFAN SR, VFAN SR Pedestal:
Unscrew the Blade Cap clockwise (Fig.
2). Then pull the blade straight out
from the shaft (Fig. 3). When replac-
ing, the blade can only go on the shaft
one way. Push the blade all the way on
the shaft until it bottoms out. Do not
use a hammer as this could result in
bearing damage. Replace the Blade Cap.
Fig. 2
Fig. 3
Blade Cap
Fig. 1
Blade Cap Nut
Washer
