3
UNPACKING INSTRUCTION
CAUTION!
!
Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REAR PANEL
1. MP3 VOLUME LEVEL
Controls the MP3 input volume
2. MIC VOLUME LEVEL
Controls the microphone input volume
3. ECHO CONTROL
Controls the echo-effect
4. MIC 1 IN
This connector can take a 6.3mm Jack
balanced cabled microphone
5. MIC 2 IN
This connector can take an XLR balanced
cabled microphone
6. LINE VOLUME LEVEL
Controls the line input volume
7. LINE IN LEFT
XLR and RCA connectors for left line signal
input
8. LINE IN RIGHT
XLR and RCA connectors for right line signal
input
9. GUITAR VOLUME LEVEL
Controls the guitar volume
10. GUITAR IN
6.3mm jack input for connecting a guitar
11. MASTER VOLUME
This knob controls the master volume
12. BASS CONTROL
Adjust the low frequencies of the
corresponding channel
13. TREBLE CONTROL
Adjust the high frequencies of the
corresponding channel
14. LED INDICATORS (VU-METER)
The current system operation is indicated
on the 5
digit LED bar graph. The LED’s
monitor the current output level within a
range of -13 dB and +3 dB
15. POWER LIGHT
Power ON/OFF indicator
16. AUX IN
Auxiliary 3.5mm input connector
17. MIX OUT
XLR connector for mix signal output
18. SPEAKER OUT 4 OHM
Passive speaker output connector, minimum load 4 Ohm! Only connect the supplied passive speaker to this connector.
19. POWER SWITCH
Turn the device ON or OFF
20. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord (top). For instructions on how to change the fuse (bo
ttom), see “REPLACING
THE FUSE
”
