EN
7
WWW.VONROC.COM
3. Speed adjustment wheel
4. Guard
5. Saw blade holder
6. Saw blade guide roller
7. Base plate
8. Hex key
9. Hex key holder
10. Dust extraction connection
11. Dust adapter
12. Grip
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Mounting and removing the saw blade
Refer to the table below to select the required saw
blade.
Saw blade
Material
Coarse
Wood
Medium
Wood
Fine
Steel, aluminium, plastic
Very fine
Wood (curves)
Remove the guard from the machine to change the
saw blade.
Always saw with guard.
Fitting a saw blade (Fig. B)
The machine is equipped with a quick blade ex-
change system.
• Turn the clamping ring (13) of the saw blade
holder (5) completely to the left, in order to
open up the holder.
• Insert the saw blade (15) in the saw blade hol-
der (5) as far as possible. The teeth of the saw
blade (15) must point upward and forward. The
smooth side of the saw blade must engage in
the slot of the guide roller (6).
•
Release the clamping ring (13) to close the holder.
• Make sure when changing the saw blade that
the blade holder (5) is free of material debris
(such as splinters of wood or metal).
• Before use, always check that the saw blade is
securely fixed.
Removing the saw blade
• Turn the clamping ring (13) of the saw blade
holder (5) completely to the left, in order to
open up the holder.
• Remove the saw blade from its holder.
• Release the clamping ring (13) to close the
holder.
4. OPERATION
Switching on and off (Fig. C)
• To switch on the machine, press the on/off
switch (1).
• To switch the machine to continuous mode,
keep the on/off switch (1) pressed and simulta-
neously press the lock-on button (2).
• To switch off continuous mode, press the on/
off switch (1) again.
• To switch off the machine, release the on/off
switch (1).
Setting the speed (Fig. C)
The speed adjustment wheel (3) is used for setting
the speed. The ideal speed depends on the profile
and the teeth of the saw blade and on the material
to be worked.
Do not set the speed during use.
• Turn the speed adjustment wheel (3) to the
required position.
-
For hard materials, use a saw blade with
fine teeth and select a lower speed.
-
For soft materials, use a saw blade with
coarse teeth and select a higher speed.
Setting the mitre angle (Fig. D)
The mitre angle is variable between 0° and 45°.
The mitre angle can be read from the scale.
Do not set the mitre angle during use.
• Slacken the Hex screws(14) using the Hex
key(8).
• Tilt the Base plate (7) to the required position.
• Tighten the Hex screws(14) using the Hex
key(8).
Dust extraction (Fig. E)
• Insert the dust extraction adapter (11) into the
dust extraction connection (10).
