TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
AIR LEAK NEAR BOTTOM OF
TOOL OR TRIGGER AREA
• O-Ring in trigger valve is
damaged.
• Trigger valve head is damaged.
Trigger valve stem, seal or O-Ring
are damaged.
• Check and replace O-Ring.
• Check and replace.
• Check and replace trigger valve
stem, seal or O-Ring.
AIR LEAK NEAR BOTTOM OF
TOOL
• Loose Screws.
• Worn or damaged O-rings or seals.
• Tighten Screws.
• Check and replace O-rings or
bumper.
AIR LEAK BETWEEN BODY
AND CYLINDER CAP
• Loose Screws.
• Worn or damaged O-rings or seals.
• Tighten Screws.
• Check and replace O-rings or
bumper.
BLADE DRIVING FASTNER
TO DEEP
• Worn bumper.
• Air Pressure is too high.
• Replace bumper.
• Adjust the air pressure.
TOOL DOES NOT OPERATE
WELL: CANNOT DRIVE
FASTNER OR OPERATION IS
SLUGGISH
• Inadequate air supply.
• Inadequate lubrication.
• Worn or damaged O-rings or seals.
• Exhaust port in cylinder head is
blocked.
• Varify adequate air supply.
• Place 2 to 6 drops of oil into air
inlet.
• Check and replace O-rings or seal.
• Replace damage internal parts.
TOOL SKIPS FASTNERS
• Worn bumper or damaged spring.
• Dirt in front plate.
Dirt or damage prevents fastners
from moving freely in the magazine.
• Replace bumper or pusher spring.
• Clean drive channel on front plate.
• Magazine needs to be cleaned.
• O-rings needs to be replaced and
lubricate.
• Replace sealing washer.
TOOL JAMS
• Incorrect or damaged fastners.
• Damaged or worn driver guide.
• Magazine or nose screw is loose.
• Magazine has become dirty.
• Change and use correct fastner.
• Check and replace the driver.
• Tighten the magazine.
• Clean the magazine.
CLEANING & MAINTENANCE
Clean dust and debris from the Air S
Nailer vents and magazine compartment using
compressed air.
Do not use solvents, or household cleaning
detergents containing ammonia to clean the
tool.
Use only mild soap and a damp cloth to clean
the tool.
Ensure you apply 2-3 drops of Machine/Air Oil
before each use.
Always unplug
the tool from the mains supply before performing any cleaning & maintenance tasks
CAUTION
Do not alter, attach special fixtures
to, or redesign parts of the tool. Do not fire
without staples, as this may cause damage.
