HOLD OR AND PRESS MODES
This mode converts the charger to a constant voltage, constant current DC power supply.
When the charger is not connected with battery, it can be used to power 12VDC devices.
Prior to use, read your 12VDC device manual to determine if it is suitable for use with this
6 mode. As a power supply, it can also be used to retain a vehicle’s on-board computer set-
tings during battery repair or replacement.
13.6V Supply Mode provides 13.6V at 9.5A with overload protection at 10A (Max). Both
spark proof and reverse polarity protection are disabled in this mode.
Do NOT allow the positive and negative battery clamp to touch or connect to each other as
the charger could generate sparks.
THESE MODES ARE ADVANCED CHARGING MODES AND FULL ATTENTION
SHOULD BE GIVEN BEFORE SELECTING
USING 12V JUMP CHARGE (PRESS)
This mode is for 12V LEAD-ACID batteries only. To operate JUMP CHARGE, the charger
must be connected to a 12V battery with the battery clamps connected.
Press the Jump Charge button to begin jumpstarting. For optimal results, allow JUMP
CHARGE to complete its 5-minute charge. After 5-minute jumpcharge, the charger will
automatically enter Standby Mode, whether 100% battery level indicator is illuminated or
not, and your are ready to start your vehicle.
If unsuccessful when starting your vehicle, let the battery rest for 15 minutes and try JUMP
CHARGE again. Most vehicles will start with one JUMP CHARGE, but larger vehicles with
dual battery systems, may require an additional JUMP CHARGE.
CAUTION! Do not use jump charge more than two times within a 24-hour period. If two (2)
jump charges cannot successfully start your vehicle, have your battery replaced or evaluated
by a local battery store.
USE THIS MODE WITH FULL ATTENTION AS THE CHARGING CURRENT IS 20A.
CHARGING MODES
Mode
Battery Size (Ah
)
Explanation
Standby
Not charging or providing any
power (Green LED)
6V STD
50-400
Charging 6V WET/GEL/MF/EFB
batteries
According to the ambient
temperature of the battery can be
intelligent compensation charge
(intelligent control).
12V STD
50-400
Charging 12V WET/GEL/MF/EFB
batteries
According to the ambient
temperature of the battery can be
intelligent compensation charge
(intelligent control).
24V STD
25-200
Charging 24V WET/GEL/MF/EFB
batteries
According to the ambient tem-
perature of the battery can be
intelligent compensation charge
(intelligent control).
REPAIR (12V/24V)
50-400
An advanced battery recovery
mode for repairing old, idle, strati-
fied or sulfated batteries.
(12V/24V) mode light Slow flash-
ing.
13.6V SUPPLY
(When the charger is not
connected with the battery
(Hold & Press)
Converting to a DC power
supply for powering 12V DC
device or as a memory retainer
when replacing a battery(“
CHARGED” LED Slow
flashing).
12V JUMP CHARGE (Press)
50-400
Delivering 20A for five (5)
minutes to jumpcharge your
battery (RED LED)
15A Battery Charger has ten modes: Standby, 6V STD, 12V STD, 24V STD, REPAIR(12V/24V) , 13.6V
SUPPLY and 12V JUMP CHARGE. Some charge modes must be held for three (3) seconds or / and
pressed to enter the mode. Do not operate the charger until you confirm the appropriate charge
mode for your battery.
