A5P | 01
CONTROL PANEL
POWER: :
When the unit is powered on the indicators and LED will display for 1 second after a ‘‘buzz’’ is heard the
power indicator will be in standby mode.
Pressing the Power Button will start the unit in default mode the fan will start and the display will indicate the
current room humidity and also colour corresponding .
BLUE
Ambient Humidity is below 45%
GREEN
= Ambient Humidity is between 45% - 65%
RED = Ambient Humidity is above 65%
If an Error code is displayed please refer to the table in the back of this manual.
Pressing the power button again will power the unit off.
MODE: Press this to cycle through Auto Mode / Continuous Mode / Sleep Mode
AUTO MODE: Both Fan speed and Humidity can be adjusted in this mode.
When the room humidity is higher than the selected humidity the fan and compressor will begin to operate after 3
seconds.
When the room humidity is below the set humidity the compressor and the fan will stop operating after a short
delay.
CONTINUOUS MODE: The humidity is not adjustable in this mode. The unit will run continuously.
SLEEPING MODE: In this mode you can adjust the humidity only.
Press the button and after 10 seconds the indicators will turn dark and the fan speed will be set to low.
To cancel sleep mode press the mode button again
NOTE: In sleep mode no error codes will be displayed and the fan speed is not adjustable.
Humidity (HUM): This can be adjusted in Aromatic and sleep mode. Pressing the button will increase the set
humidity by 5% increments, the unit will only cycle up through numbers.
To check the current room temperature press and hold the button and the display will show for 5 seconds.
TIMER BUTTON: The timer can be set
for up to 24hrs.
Pressing the timer button will increase the timer by 1hr which will be shown on the display.
The timer when set will operate until time has elapsed and the unit will go into standby mode.
To turn the timer off press the Timer Button until “00” is displayed.
FAN SPEED: This can only be changed in Automatic mode. Pressing this will cycle the fan speed between High
and Low.
LOCK: Press and hold this button and it will lock all button of from operation. To unlock press the button again, if
the unit is turned off the child lock will be deactivated.
