Page 2 of 4
Figure 5
12 VDC input
nonpolarized
Red
Red-White
Black
Black-White
Figure 4
24 VDC input
nonpolarized
Red
Black
Red-White
Black-White
12 VDC, 0.38 A
24 VDC, 0.19 A
SOLENOID POWER
REQUIREMENTS
t
u
p
t
u
o
C
D
V
2
1
t
u
p
n
i
C
A
V
2
1
t
u
p
t
u
o
C
D
V
4
2
t
u
p
n
i
C
A
V
4
2
White
White
Yellow for 12 V
Red for 24 V
Black
SO kit
For DC operation,
Von Duprin PS 861 and
Locknetics 593 DC
series power supplies
are recommended.
For AC operation,
Von Duprin SO-12 or 24
AC/DC convertor kit (shown below)
is recommended.
12 VDC Strike Wiring
24 VDC Strike Wiring
5.
Check power source voltage (12 or 24 VAC or VDC).
6.
When using 12 VAC or 24 VAC power, install SO kit to convert AC power to DC (Figure 4).
7.
Wire strike solenoid for proper voltage (Figure 5).
Caution: Do not connect 24 VDC to 12 VDC configured strike.
8.
Test strike: Apply solenoid power. Fail secure (FSE) lip unlocks. Fail safe (FS) lip locks.
9.
If cut-out for strike is too large along edge (Figure 6), cut neoprene filler and stick onto strike as shown (Figure 7).
Note: This could occur in some retrofit applications.
Neoprene filler
Cut to length and
stick on strike
Figure 6
Figure 7
Gap filled