J3905368
Connect the fibre optic cable (1) to the control module.
Install the fibre optic cable's expander clip in the hole in which
the fibre optic cable was previously secured.
Note!
Do not damage the fibre optic cables. Make sure that they are
bent to a radius greater than 25 mm (1 ”).
48
J3905371
Separate the existing antenna cable (1).
Connect the adapter cable (3) to the existing connector which is
secured in the plate.
Connect the adapter cable's connector with two cables (2) to the
control module.
Secure the adapter cable with clips around the edge of the plate
at position (4).
Connect the existing cable (5) which was detached, to the
adapter cable (4) secured with clips.
Applies to the V50
49
Applies to the V50
Finishing work
Reinstall the insulation panels on the right and left-hand sides.
Reinstall the side panels. If the car has a 12V socket, connect
the connector to this.
Tighten the screws for the load securing eyelets. Tighten to 24
Nm (18 lbf.ft.).
Reinstall the panel at the front/top of the side panel. Press
downwards so that the catches engage. Tighten using the
screw.
Reinstall the C-post panels.
Reinstall the side cushions.
Reinstall the rubber strips in the door openings.
Fold the backrests and the seat cushions back into place.
Reinstall the rubber strip in the tailgate opening.
Reinstall the sill trim panel in the tailgate opening.
Reinstall the cargo compartment carpet.
Reconnect the battery negative lead.
Programme the software.
Applies to the S40
50
Applies to the S40
Finishing work
Reinstall the side panel.
Reinstall the rubber strip in the tailgate opening.
Reinstall the sill trim panel in the tailgate opening.
Reinstall the upper floor supports if applicable.
Reinstall the cargo compartment carpet.
Reconnect the battery negative lead.
Programme the software.
© Volvo Car Corporation
Navigation system, RTI- 30732784 - V1.2