J8504639
32
J3904790
Remove the three nuts holding the amplifier to the body.
Remove the amplifier. Disconnect the front connector from the
fibre optic cables.
Applies to the S40 and V50
33A
J3905132
33B
J3904791
Applies to the S40 and V50
Installing the global positioning system module (GPS)
Illustration A
Take the GPS control module, bracket, screws and washers
from the kit.
Install the control module on the bracket so that the screw holes
correspond with the thread inserts in the bracket.
Fit the screws and washers and tighten manually.
The power cable and the antenna cable to the GPS control
module are secured under the amplifier. The antenna cable is
located in a hole on the flange under the amplifier and the power
cable is taped at the cable harness to the amplifier. These
cables must be released from the tape and clips before they are
used.
Illustration B
Remove the cover for the connector to the fibre optic cables in
the control module.
Hook in and snap the control module into place at the top edge
and opposite the rear mounting hole in the amplifier.
34
Turn the amplifier. Tighten the lower mounting from the control
module using a screw from the kit.