J3904634
35
J3905367
Reinstall the amplifier on the studs.
Install and tighten the three nuts. Tighten to 10 Nm (7.5 lbf.ft.).
Take the pre-routed antenna cable secured with a clip at
position (1) below the amplifier. Detach the power cable which is
secured with tape at the antenna cable. The clip shall not be re-
used.
Connect the antenna cable (2) to the control module.
Connect the pre-routed green 5-pin connector (3) for the power
supply to the control module.
Route the fibre optic cable previously detached from the
amplifier (4).
Note!
Do not damage the fibre optic cables. Make sure that they are
bent to a radius greater than 25 mm (1 ”).
Applies to markets outside of Europe.
36
J3905366
Applies to markets outside of Europe.
Installing the adapter cable
Take the adapter cable from the kit.
Connect the adapter's connector marked AUD to the amplifier
(1).
Connect the previously detached connector (2) to the adapter
(3).
Connect the adapter's connector marked GPS (4) to the GPS
control module.
Note!
Do not damage the fibre optic cables. Make sure that they are
bent to a radius greater than 25 mm (1 ”).
Only applies to the European market
37
J3905365
Only applies to the European market
Installing the adapter cable
Take the adapter cable from the kit.
Connect the adapter's connector marked AUD to the amplifier
(1)
Connect the previously detached connector (2) to the adapter
(3)
Connect the adapter's connector marked GPS (4) to the GPS
control module.
Connect the adapter's connector marked TMC to the pre-routed
connector (5).
Note!
Do not damage the fibre optic cables. Make sure that they are
bent to a radius greater than 25 mm (1 ”).
Applies to the S40, European market only.
38
Applies to the S40, European market only.
Installing the traffic message channel module (TMC)
Fold the rear seat backrests forward.