Volvo V 40, Owner'S Manual

Page: 143 / 492

04 Climate control
04
*
Option/accessory, for more information, see Introduction.
141
Engine block heater and passenger
compartment heater* - direct start/
immediate stop
Upon direct start of the engine block and pas-
senger compartment heater (p. 140), it will run
for 50 minutes.
Heating of the passenger compartment will
begin as soon as the engine coolant has
reached the correct temperature.
NOTE
The car can be started and driven while
the heater is running.
1. Press OK to access the menu.
2. Scroll with the thumbwheel to Parking
heater
and select with
OK
.
3. Scroll forward in the next menu to Direct
start
/
Stop
in order to activate/deactivate
the heater and select with
OK
.
4. Exit the menu with RESET .
Related information
•
Engine block heater and passenger com-
partment heater* - timer (p. 141)
•
Engine block heater and passenger com-
partment heater* - messages (p. 142)
Engine block heater and passenger
compartment heater* - timer
The timer of the engine block and passenger
compartment heater (p. 140) is connected to
the car's clock.
Two different times can be selected using the
timer. Here, time refers to the time when the
car is heated and ready. The car's electronic
system calculates when heating should be
started based on the outside temperature.
NOTE
All timer programming will be cleared if the
car's clock is reset.
Adjusting
1. Press OK to access the menu.
2. Scroll with the thumbwheel (p. 101) to
Parking heater and select with OK .
3. Select one of the two timers using the
thumbwheel and confirm with
OK
.
4. Briefly press OK to move to the lit hours
setting.
5. Select the required hour using the thumb-
wheel.
6. Briefly press
OK
to move to the lit
minutes setting.
7. Select the required minute using the
thumbwheel.
8. Press
OK 3 to confirm the setting.
9. Go back in the menu structure using
RESET
.
10. Select the other time (continue from step
2) or exit the menu with RESET .
Starting
1. Press OK to access the menu.
2. Scroll with the thumbwheel to
Parking
heater
and select with
OK
.
3. Select one of the two timers using the
thumbwheel and activate with OK .
4. Exit the menu with
RESET
.
Switching off
A timer-started heater can be switched off
manually before the set time has elapsed.
Proceed as follows:
1. Press
OK to access the menu.
2. Scroll with the thumbwheel to Parking
heater
and select with
OK
.
> If a timer is set but not activated, a
clock icon is shown next to the set
time.
3. Select one of the two timers using the
thumbwheel and confirm with
OK
.
3 Press OK again to activate the timer.