Volvo C70, Owner'S Manual

Page: 83 / 304

02 Instruments and controls
HomeLink
Ÿ Ÿ
*
02
*
Option/accessory, for more information, see Introduction.
83
•
Constant glow: The indicator lamp illu-
minates with a constant glow when the
button is kept depressed, this indicates
that the programming is complete. The
garage door, gate or similar should now
be activated when the programmed
HomeLink
Ÿ
button is depressed.
•
Glow not constant: The indicator lamp
flashes quickly for approx. 2 seconds
and then changes over to a constant
glow for approx. 3 seconds. This proc-
ess is repeated for approx. 20 seconds
and indicates that the device has a "roll-
ing code". The garage door, gate or sim-
ilar is not activated when the pro-
grammed HomeLink
Ÿ
button is
depressed. Continue the programming
in accordance with the following.
5.
Locate the "programming button
2
" on the
receiver for the garage door for example,
normally located close to the antenna's
bracket on the receiver. If you have diffi-
culty in finding the button - consult the
supplier's manual, or contact the supplier
via the Internet: www.homelink.com.
6. Depress and release the "programming
button". The button flashes for approx. 30
seconds and the next step must be carried
out within this period.
7. Depress the programmed button on
HomeLink
Ÿ
, while the "programming but-
ton" is still flashing, keep it depressed for
approx. 3 seconds and then release.
Repeat the press/hold/release sequence
up to 3 times to conclude the program-
ming.
Erasing programming
It is only possible to erase the programming for
all the buttons on HomeLink
Ÿ
, not for individual
buttons.
Depress the two outer buttons and do not
release until the indicator lamp starts to
flash after approx. 20 seconds.
> HomeLink
Ÿ
is now set in so-called
"learn mode" and is ready to be pro-
grammed once more, see page 81.
2 Button designation and colour vary depending on manufacturer.