9
IMG-265072
Accessory installation
Using a sharp knife, first make a thin cut along the edges of the
marking inside of the bumper cover. Then carefully cut the
bumper cover.
Note!
Cut carefully. It is easy to slip with the knife and move outside
the markings.
Install the protective cover for the front engine block heater
socket from the kit. Check that it aligns.
Note!
Ensure that the protective cover is turned the correct way
(shown in next image).
Adjust the hole with a knife as necessary.
Smooth off the hole edges. Remove any swarf.
10
IMG-265073
Install the connector for the fog lamp and parking assistance
connector (if applicable) and reinstall the bumper section.
Using a sharp knife, first make a thin cut along the edges of the
inner section of the bumper flush with the prepared hole on the
outer bumper section.
Note!
Cut carefully. It is easy to slip with the knife and move outside.
Install the protective cover for the front engine block heater
socket from the kit. Check that it aligns.
Note!
Ensure that the protective cover is turned the correct way, see
image.
Adjust the hole using a knife or file if necessary.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Electric engine block heater 110V- 31399531 - V1.0
Page 8 / 22
