25
Applies to cars from and including model year 2005-
(CH459000-)
– Install the screw (1) in the upper edge of the end face
on both sides.
– Install the screw (2) in the lower edge of the wheel
arch on both sides.
– Install the four clips.
Applies to cars with rear mudflaps
– Rivet in the mudflap.
– Reinstall the wheels and tighten the screws alternately
to
110 Nm (81 lbf.ft.)
.
26
Install the rubber tabs from the kit over the four
installed screws as follows:
– Align the rubber tabs (1) edge to edge with the lining
mat.
– Compress the rubber tab (2) slightly to align in the
cut-out.
– Align the rubber tab (3) so that the lower edge is
positioned edge to edge with the lining mat. Then cut
off the section protruding from the lining mat. Do not
remove too much.
27
– If necessary, cut away the area (1) around the screw
heads, so that the screws are accessible.
28
– Check the function of the detachable towbar.
29
– Remove the towbar and place it in the protective bag.
– Place the towbar in the spare tyre as illustrated.
– Thread the strap through the two nearest holes in the
wheel and route the strap around the towbar.
– Insert the strap into the tensioner. Tighten the strap
until the towbar is secured and stable.
30
– Take the protective cover from the kit.
– Install it into the hole where the towbar shall be
located and press it in.
31
– Install the enclosed decal (1) on the underside of the
floor hatch. Staples can be used for more secure
fitting.
32
– Install the cable harness for the towbar according to
the appropriate Installation Instructions.
33
–
Applies to cars with parking assistance:
Connect
the detached cable to the parking assistance module.
Reinstall the control module.
– Turn the ignition key to position II.
Reinstall:
– The battery negative lead
– The battery cover and holder
– The side panel
– The storage cover and the floor hatch.
34
– Remove the masking tape from the bumper.
2006 12 31213957