7
Applies to cars up to and including model year –2004
(CH -458999)
Check if the car has clips
– Remove the clips (1) underneath the bumper cover by
pressing in the centre of the clip until a clicking sound
is heard. Remove the clips. The clips shall be re-used.
Applies to all models
– Pull the bumper backwards slightly. Bend out the
sides (2) so that they detach from the mounting (3).
Then pull the bumper backwards until it detaches
completely.
– Place the bumper on a clean underlying surface that
will not damage the paint.
Applies if the car has moulding
– Carefully remove the moulding (4) from the expander
screws.
8
Applies to cars from and including model year 2005
(CH459000-)
– Remove the screw (1) in the upper edge of the end
face on both sides.
– Remove the screw (2) in the lower edge of the wheel
arch on both sides.
– Push in the centre of the four clips on the underside of
the bumper cover. Remove the four clips by pulling
them through the holes.
– Place the bumper on a clean underlying surface that
will not damage the paint.
9
Applies to cars with parking assistance
– Detach the bumper in accordance with the above.
Carefully pull the cable (1) out through the hole in
the car.
10
Illustration A
– Remove the rivet (1) on the bracket (2) for the silencer.
Use cutting nippers.
– Remove the screws (3) on the bracket.
– Remove the rubber mountings (4). Remove the
bracket. The bracket will not be used again.
Illustration B
– Remove the screws (1). Remove the bracket (2). The
bracket shall not be re-used.
11
Illustration A
Applies to V70, V70R from and including model year
2005– (CH 459000–), Europe and Australia
– Cut along the markings on the inside of the bumper to
make the cut-out for the towbar. Cut out so that the
marking lines remain in the bumper afterwards.
Illustration B
Applies to the Australian towbar with chain
mountings.
– Install masking tape opposite the smaller cutting lines
(2).
– Drill a hole inside each marking for the blade of the
jig saw.
– Cut the material out inside the marking lines.
– After cutting, smooth off the edges using a file.
12
Applies to V70R up to and including model year
–2004 (CH -458999)
– Apply masking tape on the outside of the exhaust pipe
clip to avoid damage from the base of the saw. Leave
the masking tape in place during installation.
– Cut along the marked raised area and remove the
cut-out area.
13
Illustration A
Applies to cars up to and including model year –2004
(CH -458999)
– Use the cutting template from the kit to pre-mark the
cutting lines on the inside of the bumper. Position the
cutting template as illustrated.
– Carefully mark out the cutting lines around the cutting
template.
– Cut along the markings on the inside of the bumper to
make the cut-out for the towbar. Cut out so that the
marking lines remain in the bumper afterwards.
Illustration B
Applies to the Australian towbar with chain
mountings.
– Use the smaller cutting templates from the kit to
pre-mark the cutting lines on the inside of the bumper.
Position the cutting template as illustrated.
– Install masking tape opposite the smaller cutting lines.
– Drill a hole inside each marking for the blade of the
jig saw.
– Cut the material out inside the marking lines.
– After cutting, smooth off the edges using a file.
2006 12 31213957