78
IMG-329256
Applies to all cars that do not have a pre-mounted display.
Routing cable harness C
Take cable harness C from the kit. The shorter ground lead has
a lot of excess that can be hidden under the mat by the left-hand
seat.
79A
IMG-329257
79B
IMG-329258
Illustration A
Tilt the left-hand seat back.
Place the two large connectors for the cable harness where the
two 32-pin connectors were previously disconnected from each
other.
Route the thinner ground leads (1) into the mat joint in the same
direction as cable harness B, along the member for the front
seat mounting where the control module will be installed later
on.
Pull up the shorter ground lead (2) from the mat joint so that
approximately 350 mm 13 3/4 " protrudes from the mat joint.
Continue to route the longer of the ground leads the same way
as cable harness A backwards towards the rear crossmember.
Note!
Ensure that the cables do not come into contact with moving
parts in the tunnel console and that they are not at risk of being
cut.
Illustration B
Only applies to left-hand drive vehicles.
Route through the thicker cable (3) to the display through the
tunnel console in front of the air ducts and out the other side.
Use a wire to route the cables through, if necessary.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Parking assistance, camera, rear, (Ch -175378)- 30756319 - V1.2
Side 46 / 87
