Volvo 2015 S60, Owner'S Manual

Page: 159 / 406

04 Driver support
Adaptive Cruise Control (ACC)*
04
}}
*
Option/accessory, for more information, see Introduction.
157
WARNING
Adaptive Cruise Control only warns of
vehicles detected by the radar sensor, see
page 162. In some cases there may be no
warning or the warning may be delayed.
The driver should always apply the brakes
when necessary.
Steep inclines and/or heavy loads
ACC is primarily intended for use on fairly
level roads. The system may have difficulty
maintaining the correct distance to a vehicle
ahead on steep inclines, if the vehicle is car-
rying a heavy load or is towing a trailer. In
these situations, the driver should always be
prepared to apply the brakes if necessary.
Operation
Controls and display
Resume previous settings.
Off/On/Standby mode
Decrease/increase time interval
Put in active mode and set a speed (each
additional press increases/decreases
speed by 1 mph (approximately 2 km/h))
Set speed (shown in
green when active,
shown in white when in standby mode)
Time interval
ACC active (
green
symbol) or in standby
mode (
white
symbol)
Putting ACC in standby mode
Before ACC can be used to regulate speed
and/or the distance to a vehicle ahead, it
must first be put in standby mode.
To do so:
•
Press (2).
> The same symbol (7) appears (in white ) in
the instrument panel to indicate that ACC
is in standby mode.
NOTE
The driver's door must be closed and the
driver's seat belt must be fastened before
ACC can be put in active mode. If the driv-
er's seat belt is taken off or if the driver's
door is opened, ACC will return to standby
mode.
Setting a speed
Once ACC has been put in standby mode:
•
Press or (4).
> The set speed, for example 60 mph (5),
will be magnified for several seconds and
the frame around the speed will change
colors from white to green to indicate
that this speed has been stored (set).