23
15
Screw tight the cover with its gasket on the cooling water pump.
Connect the hose between the cooling water intake and the
reverse gear. Check-tighten all the hose clamps.
Close the drain cocks.
Clean the outside of the engine and the reverse gear.
16
Install the battery, which should be fully charged. Grease the
cable shoes. Connect up the battery cables. IMPORTANT! Do
not mix up the polarity. Tighten up the cable shoes well.
17
Remove the injector. Take measures to avoid oil splash and run
the engine several turns so that the oil on the piston crowns is
blown out.
Fit the injector. See under “Tightening torques”, “Technical
Data”.
18
Launch the boat. Change the fuel-filter cartridge. Pump forward
the fuel and vent the system. See under “Venting the fuel
system”.
19
Start the engine. See the instructions on page 5. Run the
engine warm with the reverse gear engaged. Check to make
sure there is no leakage of fuel, air, water or exhaust gases .
Check that all the controls, etc., are functioning properly.
20
If necessary, contact authorized Volvo Penta service shops and
let them service the engine and reverse gear according to the
instructions in the servicing scheme.
LAYING-UP AND LAUNCHING
