89
Diagnostic function
Code 2.4 Engine speed (RPM) sensor
Cause:
The engine speed (RPM) sensor transmits no
signal to the control module at start.
Consequence:
The engine does not start/The starter mo-
tor is not activated.
Corrective action:
• Check the connections for the engine speed (RPM) sen-
sor, the starter relay and the control module.
• Erase the diagnostic trouble code (DTC).
• Start the engine.
• Contact an authorised workshop if the fault persists.
Code 2.5 Engine speed (RPM) sensor
Cause:
The engine speed (RPM) sensor transmits abnor-
mal values to the control module during operation.
Consequence:
The engine stops.
Corrective action:
• Check the connections for the injection pump (the actua-
tor) and the control module.
• Erase the diagnostic trouble code (DTC).
• Start the engine.
• Contact an authorised workshop if the fault persists.
Code 2.6 Potentiometer
Cause:
Short-circuit or open-circuit in the power supply to
the potentiometer in the control.
Consequence:
The gear is disengaged and the engine
speed (RPM) is set to 1000 rpm.
NOTE!
The fault applies to the relevant control position
(the boat can be driven from another control position if
there are multiple control positions).
Corrective action:
• Check the wiring and connections leading to the control.
• Erase the diagnostic trouble code (DTC).
• Start the engine.
• Emergency shifting is possible if the fault remains: See
the “Fault-tracing” chapter.
Code 2.7 Potentiometer
Cause:
The control module receives no information from
the potentiometer in the control (applies to the potentiom-
eter for the engine speed lever in dual lever controls).
Consequence:
The gear is disengaged and the engine
speed (RPM) is set to 1000 rpm.
NOTE!
The fault applies to the relevant control position
(the boat can be driven from another control position if
there are multiple control positions).
Corrective action:
• Check the wiring and connections leading to the control.
• Erase the diagnostic trouble code (DTC).
• Start the engine.
• Emergency shifting is possible if the fault remains: See
the “Fault-tracing” chapter.
Code 3.1 Potentiometer
Cause:
The control module receives no information from
the potentiometer for the gear selector lever (dual lever
control only).
Consequence:
The gear is disengaged and the engine
speed (RPM) is set to 1000 rpm.
NOTE!
The fault applies to the relevant control position
(the boat can be driven from another control position if
there are multiple control positions).
Corrective action:
• Check the wiring and connections for the potentiometer
and the wiring and connections leading to the control
position.
• Erase the diagnostic trouble code (DTC).
• Start the engine.
• Emergency shifting is possible if the fault remains: See
the “Fault-tracing” chapter.
Code 3.3 Temperature sensor
Cause:
The control module receives no signal from the
engine coolant temperature (ECT) signal.
Consequence:
The engine is difficult to start, there is ex-
cessive smoke when the engine is cold.
Corrective action:
• Check the sensor and the connections and wiring for the
sensor and control module.
• Erase the diagnostic trouble code (DTC).
• Start the engine.
• Contact an authorised workshop if the fault persists
Summary of Contents for KAD/KAMD300
