Volvo Penta D9 MH, Operator'S Manual

Page: 33 / 116

Set display contrast
Press button 5 (furthest right) to set display contrast.
Then press the appropriate buttons to adapt the le-
vels, then save the settings by pressing EXIT. The
display unit has 5 contrast settings.
Configuration menu (button 5)
(depressed for longer than 3 s)
The configuration menu is used to:
-
access the display mode SYSTEM INFORMA-
TION .
- do various settings for the display.
- reach information and functions for servicing the
display.
Please refer to the configuration menu structure be-
low and read the following section, which explains
each section in the menu.
note! The port engine or both engines must have the
ignition switched on when display settings are chan-
ged.
Configuration menu structure
System
Information
Language (8 available)
Bleep
ON, OFF
Engine
PORT, STARBOARD
TWIN, SINGLE
Engine series
D1/D2, >D2
Settings
GLOBAL, LOCAL
Display
Units
Settings
System
Engine [2500 rpm: 9000 r/min] in stages of 500 rpm
Speed On, off
Speed [10 KNOT: 100 KNOT] in stages of 10 (in appropriate units)
Graph interval 2MIN, 10MIN, 30MIN, 60MIN, 2 H, 4 H, 8 H
Read more about this display mode
on the next page
Speed Knots, mph, km/hr
Distance NM, Miles, km
Oil pressure kPa, psi
Turbo pressure kPa, psi
Fuel consumption Liter/hr, Gal(US)/hr, IGal/hr
Temperature degrees C, degrees F
Volume Liter, Gal(US), Imperial Gallons
Depth (std distance) m, ft
Menu
SYSTEM
is for ser-
vice technicians
The
UNITS
menu is
only available if
LOCAL
has been selected in
the menu SETTINGS
Demo
Com Viewer
Prog. tx
About
31
Instruments