Volvo Penta D3, Operator'S Manual

Page: 15 / 142

Backlighting
Panel backlighting can be adjusted by pressing
simultaneously.
Start/Stop Panel
The start/stop panel is used for starting and stopping
the engine.
To start the engine it is necessary for the ignition to be
switched on at the key panel.
Read the starting instructions in chapter
Starting page 52 and Engine Shutdown page 59 to
ensure you use the correct start procedure.
Power Trim panel
The Power Trim panel allows you to adjust the angle
of the drive with respect to the transom.
For twin engine installations, the control panel can be
used to make individual or simultaneous adjustments
to the drives.
By trimming out the drive away from the transom, the
bow will be ”raised” in relation to the horizontal axis and
trimming in the drive will ”lower” the bow of the boat
+ Will trim the drive away from the transom, the bow
will be ”raised” in relation to the horizontal axis.
– Will trim the drive away towards the transom, ”lower”
the bow of the boat.
For further information on Power Trim refer to Instru-
ments and Controls page 32 .
Cruise Control
Switch on cruise control by pressing the button.
Make fine adjustments to the locked engine speed by
pressing the + or – buttons to increase or reduce it.
P0001259
Instruments and Controls
47705992 05-2015 © AB VOLVO PENTA 13