91
Repair Instructions
72
Supercharger belt
Loosen the nut far enough to allow the belt to slacken
off. Tension the belts by applying a torque of 35–40
Nm (26–30 lbf-ft) to the domed nut on the tensioner
screw. Use a torque wrench and a suitable socket.
Lock the tensioner screw with nut (1).
73
Servo pump belt
Undo retaining screw (1). Tension the belt with adjust-
ment screw (2), so that the belt can be pressed down
about 10 mm (0.3937") between the pulleys. Tighten
screw (1).
IMPORTANT! Re-check belt tension on all belts
after the engine has warmed up. Do this check
while the belt is still warm.
74
Install the engine cover at the front.
Before starting
●
Fill engine oil. Check level.
●
Fill coolant. Check level.
●
Check oil level, compressor (KAD/KAMD
32/42/43/44/300).
●
Check that all wiring is connected and that all ter-
minals are properly fastened. Check that the wir-
ing is correctly clamped so that it is not exposed
to mechanical wear.
●
Check that all the hose clamps on the engine
coolant and air hoses are tightened.
●
Open any sea water cocks.
●
Bleed the fuel system if it has been dismantled.
After starting
Run the engine to operating temperature so that the
thermostats open. Then check:
●
That no water-, oil-, or fuel leakage occurs.
Stop the engine and carry out the following
checks:
●
Check the engine oil level. Top up if required.
●
Check the fresh water level. Top up if required.
●
Check belt tension. Adjust as necessary.
