55
Insert the sleeve and the tool into the cylinder head.
Mount the injector mounting nut and press the pack-
age with the mounting screw until the copper sleeve
bottoms in the cylinder head.
IMPORTANT! Note that when installing with the
cylinder head mounted, the piston must not be
at Top Dead Center (TDC) when the installation
takes place. The piston may be damaged by
the tool during installation.
5
Hold the tool stem and screw the large nut down. The
drift clamp is then pressed up through the lower part
of the copper sleeve.
Screw down the nut until the tool stem releases from
the sleeve. Then pull up the stem and the remove the
rest of the tool from the cylinder head.
Applies to 44/300 series
3
Remove the drift clamp (1) from tool 885 237.
Slacken off the tool stem nut (2).
Install the new steel ring and the new copper sleeve
on the tool and screw in the drift clamp.
NOTE! Grease the drift clamp.
4
Repair Instructions