© Voltex Electrical 2016. All Rights Reserved.
®
11.
Carefully cut around the line. Several holes drilled at a point inside the
marking will provide a convenient starting point for cutting the panel out.
12.
Remove the facia of the exhaust fan by pushing the spring on each side
together and then guide it through the slot.
13.
There are three mounting clips on the VEFLED-200 and four mounting
clips on the VEFLED-250. Turn all mounting clips toward the body of the
exhaust fan (centre).
14.
Insert fan into hole.
15.
Using a screwdriver, tighten the screws of the mounting clips in a clockwise
direction to lock the clips and exhaust fan in place to the ceiling.
16.
Replace the fascia by pushing the spring on each side together and guiding
it back through the slot.
17.
Unscrew the terminal cover and make the electrical connections (as per
Figure 2
.
Wiring diagram below). Once the wiring is connected, replace
the
terminal cover and locate cabling to allow room for the appliance to
be
positioned in the ceiling cavity.
18.
WARNING:
The appliance shall, under no circumstances, be covered with
insulating material or similar material.
19.
Reconnect the power.
20.
Switch on appliance and check correct function and switch operation.
21.
Your installation is now complete.
Figure 1
.
Dimensions
Model
Dimension A (mm) Dimension B (mm)
Dimension C (mm)
VEFLED-200
260
174
240
VEFLED-250
335
178
310
Figure 2
.
Wiring Diagram
