© Voltex Electrical 2015. All Rights Reserved.
®
1.
For the exhaust fan to work efficientl
y
, replacement air of a volume
equivalent to what is being extracted must be able to enter the room. In
general, this air would be drawn under the door, or through a slightly open
window. If the room is airtight, the fan will function poorly.
2.
This appliance is designed for installation in flat ceilings ON
L
Y. Do not
mount it on a sloping ceiling or a vertical wall.
3.
Before commencing any cutting, check that there are no obstructions
such as ceiling joists and that there is sufficient height clearance or the
housing and routing of the duct. Check that the electrical wiring can be
routed from the wall switches to the mounting location.
7.
This appliance is designed for indoor use only.
8.
Do not allow any foreign object to enter through the facia opening or outlet
as this may damage the appliance and/or the user.
9.
The appliance shall, under no circumstances, be covered with insulating
material or similar material.
10.
Do not locate the appliance immediately below a socket-outlet.
11.
This appliance is designed to provide infra-red radiant heat to warm the
body while drying, when standing directly underneath. It is not designed
as
a room heater.
12.
WARNING: This appliance is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are
occupied by persons not capable of leaving the room on their own, unless
constant supervision is provided.
13.
WARNING: Curtains and other combustible material may ignite if in contact
with the appliance or if the appliance is installed to close.
14.
Make sure that the power is OFF before installation.
15.
When cutting into the mounting surface, do not damage electrical wiring
and other hidden utilities.
16.
The appliance must be properly connected to the protective earthing
conductor in the fi
x
ed wiring of the installation.
17.
Precautions must be taken to avoid the back-fl
o
w of gases into the room
from the open flue of gas or other fuel-burning appliances
18.
FOR SAFE USE OF THIS APPLIANCE, AFTER INSTALLATION, DISCONNECTION
OF THE APPLIANCE FROM THE SUPPLY SHALL BE POSSIBLE. MEANS FOR
ALL POLE DISCONNECTION MUST BE INCORPORATED IN THE FIXED WIRING
IN ACCORDANCE WITH THE WIRING RULES.
IMPORTANT CONSIDERATIONS BEFORE INSTALLING
A few minutes planning can make a big difference to the installation time and to
your satisfaction with the function of the appliance.