T
HE
M
ENU
S
YSTEM
Page 36
© Voltech 2010
Power Analyzer User Manual
Auto Zero
Normally the will cancel any small dc offsets in the measurement
automatically. This is called Auto Zero.
Auto Zero should always be enabled.
Select
Disable and Enable and press
to confirm.
Clock Setup
These options may be used to check or set the ‟s internal clock.
To select a menu item, use the
keys and then press
for detailed options.
Set Time - Enter the time using the format shown and press
OK
to confirm.
Set Date - Enter the date using the format shown and press
OK
to confirm.
Time Format - Select
12 Hour or 24 Hour
and press
to confirm.
Date Format - Select
the required date format
and press
to confirm.
Unit Configuration
For units with firmware version 4.13 or later, the Unit Configuration menu displays
the hardware revision, firmware revision, serial number, date and type of last
adjustment and whether IEC mode has been enabled. To meet the enhanced
specification for 45-
65Hz, the adjustment type must be “enhanced”
IEC Key Code Entry
This is used to enable the IEC Pre-Compliance PC software. After the software
has been enabled, this menu item will be disabled.
The status of the IEC Pre-Compliance Software (Enabled or Disabled) can be
viewed in the Unit Configuration menu.
4.10.
U
SER
C
ONFIGURATION
.
Save and recall your set up.
To select a menu item, use the
keys and then press
for detailed options.
The first option is to „Load Default‟. Choosing this option will set every menu
option of the to its factory default.
The other menu items (Default „CONFIGURATION n‟) may be used to store and
recall all settings of the
