INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
Install Extension Riser on Fixture
1
Using a screwdriver, remove the
bottom 4 screws from the fixture body.
Pull the lead wire into the center of
the fixture through the side wire exit
and then place it through the center
hole going back out. Attach the bottom
back onto the fixture body and secure
with the previously removed screws.
Thread a coupler and lock nut to
the bottom of the fixture body. Then
attach the extension riser, running the
wire through all pieces.
Fixture
Body
Bottom Screw
Install Stake
2
Determine the desired location for
mounting the fixture. Hammer the stake
into the ground until flange of stake is flush
to grade. To avoid damage to the stake,
place a board on top of the stake while
hammering.
NOTE: If the ground is hard and the stake
is difficult to install, make a crosscut in the
ground using a flat shovel.
Board
Stake
Soil
Ground
- 4 -
OPTION A: MOUNT TO STAKE
VOLT
®
Guardsman Post Top Light
VPL-1011-4-BBZ
Coupler
Lock Nut
