www.volt-equipment.com
M
a
in
te
n
a
n
c
e
INSPECTION AND START UP
INSPECT YOUR PRESSURE WASHER CAREFULLY FOR ANY DAMAGE THAT MAY HAVE OCCURRED DURING
TRANSIT. BE SURE TO INSPECT AND TIGHTEN ALL BOLTS, SCREWS, AND FITTINGS BEFORE ATTEMPTING
TO START THE UNIT.
DO NOT ATTEMPT TO OPERATE A DAMAGED UNIT. IT MAY CAUSE SERIOUS INJURY OR
PROPERTY DAMAGE!
LUBRICATION
•
Check the oil prior to each operation per the engine
manual
.
START-UP
•
Properly fill engine with gas and oil. (See engine
Manual)
•
If desired, connect the soap line to the soap intake
connection and place filter end in soap supply.
•
Connect the water supply to the water intake.
•
Connect the high pressure hose to the trigger gun
and pump.
•
Turn the inlet water hose fully to the “ON” position.
Assure no kinks in the hoses.
•
Before starting the engine, squeeze the trigger to
allow the water to fill the pump.
•
Start the engine per the supplied engine manual.
WARNING
•
•
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation
•
The trigger gun traps high water pressure, even
when engine is stopped. Relieve trapped water
pressure in the pump, hose and trigger gun by
squeezing the trigger AFTER the engine has
completely stopped.
•
DO NOT allow children to operate pressure washer
•
Never repair high pressure hose. Replace it.
•
Never repair leaking connections with sealant of
any kind. Replace o-rings and seals.
•
Never connect high pressure hose to the extension
wand.
•
NEVER try to disconnect any water connections
without first turning the unit OFF, turning the inlet
water OFF and relieving all trapped pressure!
•
Always point spray gun in safe direction, squeeze
spray gun trigger to release high pressure every
time you STOP engine
•
Never aim spray gun at people, animals, OR
electrical devices.
•
Do not secure spray gun in open position
•
Do not leave machine unattended.
•
Never use a spray gun which does not have a
trigger lock OR trigger guard in place and in
working order.
•
Always assure spray gun, nozzles and accessories
are correctly attached.
•
Do NOT spray electrical devices with water.
•
For outdoor use only.
•
Empty the fuel tank and restrain the pressure
washer prior to transporting in a vehicle.
Do not use any attachments or accessories not
recommended by the manufacturer. The use of
attachments or accessories that are NOT recommended
can result in serious injury or damage to the equipment.
If the engine does not start, after each pull of the
recoil starter squeeze the trigger to relieve trapped
pressure before attempting to start the engine.
NEVER direct water stream toward people, pets, or any
electrical device.
The trigger gun traps high water pressure, even
when engine is stopped. Relieve trapped water
pressure in the pump, hose and trigger gun by
squeezing the trigger AFTER the engine has
completely stopped.
005
Summary of Contents for PRO POWER VK3000P
Page 16: ......