Volt PRO POWER VK3000P, Operator'S Manual

Page: 10 / 16

www.volt-equipment.com
Nozzle Application
0º Red
•
Spot cleaning of high, hard-to-reach areas
• Removing heavy mud from heavy con-
struction, farm, or lawn equipment
• Cleaning overhead areas
•
Removing rust from steel and oxidation from
aluminum or small overhead surfaces.
15º
Yellow Removing heavy mildew stains
Removing marine growth or algae from boats
and similar equipment
Removing rust from steel
•
Removing grease or dirt from equipment
•
• Removing paint from wood, masonry or
metal
25º
Green
•
For general purpose or large surfaces
General cleaning of dirt, mud, and grime
Cleaning gutters, and downspouts
Removing light mildew stains
•
Rinsing surfaces in preparation for painting
40º
White
•
For wide-angle rinsing
•
Light cleaning and washing
•
Washing and rinsing of painted surfaces and
boats
•
Cleaning windows, patios, and driveways
Soap
nozzle
•
For all detergent applications and for gentle
rinsing
Table 1
Notice: All pressure and flow ratings are per PWMA PW101-1998
Using detergent
•
Use only detergents designed for pressure washers;
household detergents, acids, bleaches, caustic
solutions, solvents or flammable liquids will damage
the pump and void the warranty.
•
Connect the soap injection tube to the soap injector
on the pump. See photo below.
•
Place the injector hose with filter directly into the soap
bottle. This machine will automatically mix the soap
solution at a 20:1 ratio.
NEVER change nozzles without turning off the
pressure washer, relieving all system pressure and
locking the lock out on the trigger handle.
•
Spray the detergent on a dry surface using long
overlapping strokes. Do not allow soap to dry on
the surface.
•
Follow the instructions provided with the cleaning
solution.
•
Before storage, place injector filter in a clean bucket
of water and flush soap from the pump for 1 to 2
minutes.
Rinsing
•
Select the proper nozzle per table 1.
•
Start at the top of the surface and work your way
down the surface using long overlapping strokes.
•
To adjust the pressure of the unit, see figure 7.
The trigger gun traps high water pressure,
even when engine is stopped. Relieve trapped
water pressure in the pump, hose and trigger
gun by squeezing the trigger AFTER the
engine has completely stopped.
009