www.volt-equipment.com
TROUBLESHOOTING
Problem
Cause
Solution
Engine is running but no water is
flowing.
1. Water is turned off.
2. Hose is kinked
3. Inlet filter is stopped up.
4. Nozzle is plugged.
5. Pump seals are damaged
1.
Turn supply water “on”.
2.
Unwind hose and remove kinks.
3.
Remove garden hose from pump;
clean the stainless steel mesh screen.
4.
Unclog nozzle per
instructions.
5.
Replace pump, Contact
CUSTOMER
SERVICE
1-888-207-8658
Engine runs good until loads are
connected, then bogs down.
1. High pressure nozzle is clogged.
2. Defective pump.
3. Engine speed is too slow.
1.
Unclog nozzle per
instructions.
2.
Contact
CUSTOMER SERVICE
1-888-207-8658
3.
Increase engine speed per
engine
manual.
Engine will not start or engine starts
but runs rough.
1. On/Off Switch is turned ‘OFF’.
2. Dirty air cleaner.
3. Out of fuel.
4. Stale fuel.
5. Not enough speed or force is used
for recoil start.
6. Water in fuel.
7. Speed control is not set to
“Run”.
8. Low Oil Level.
9. Engine has lost compression.
10. Clogged carburetor
1.
Turn On/Off switch to “on”
2.
Clean air filter
3.
Fill fuel tank
4.
Drain fuel tank into an approved
container and refill with fresh fuel.
5.
Read and follow directions
6.
Drain fuel tank into an approved
container and refill with fresh fuel.
7.
Move speed control to the “run”
position
8.
Add oil to the proper level
9.
Contact
CUSTOMER SERVICE
1-888-207-8658
10.
Clean carburetor
Engine shuts down during Operation.
1. Out of fuel.
2. Fault in engine.
3. Engine oil level is low.
1.
Fill fuel tank.
2.
Contact
CUSTOMER SERVICE
1-888-207-8658
3.
Add oil to proper level.
Pump leaks water
1.
Thermal Release Valve leaks
water.
2.
Pump seals or valves are worn.
1.
The water temperature inside
the pump has exceeded the
set limit; squeeze the trigger
to allow cool water to flow
thru the pump. Do not allow
pressure washer to idle for
extended
periods.
2.
Replace pump, Contact
CUSTOMER
SERVICE
1-888-207-8658
MAINTENANCE SCHEDULE
DAILY
MONTHLY
6 MONTHS
YEARLY
Check Oil Level
x
Check For Oil Leaks
x
x
Replace Air Filter
x
Change Oil
x
011
Summary of Contents for PRO POWER VK3000P
Page 16: ......
