Owner’s Manual #513666
10
M202B Model Machines
B.
Product Selector Switch
The product selector switch changes the
refrigeration profile of the right freezing cylinder
to allow two different products to be made. Before
the machine is in ready mode, this switch can be
moved to the desired profile.
C.
PUSH TO FREEZE Button
The PUSH TO FREEZE button initiates the run
mode. To start the machine, place the Freezing
Cylinder OFF-ON switch in the ON position then
press the PUSH TO FREEZE button.
D. LEDs
The membrane switch features two lights; a green
LED and an amber LED. The green LED flashes
when the freezing cylinder is near ready mode
and stays lit during ready mode. The amber LED
is lit during standby, purge and clean modes.
NOTE
If the machine enters an error condition, alternating
green and amber lights flash. The LCD displays an
error. Turn the Freezing Cylinder OFF-ON switch
to the OFF position, correct the problem (Refer to
Troubleshooting in Section 4) and turn the machine
back on.
E.
PURGE/CLEAN Button
PURGE Mode
- When the PURGE/CLEAN button
is pressed, the auger rotates. A PURGE message
displays on the screen along with a 5-minute
timer. Hopper refrigeration continues to run. When
the timer gets to 0:00 and no other buttons are
pressed, the machine enters standby mode.
CLEAN Mode
- During PURGE mode, if the
PURGE/CLEAN button is pressed, the CLEAN
mode begins. The auger continues to rotate and
hopper refrigeration stops.
F.
Mix Low Light Indicator
The MIX LOW message appears on the LCD display
to alert the operator of a low mix condition. The
message displays when there is approximately one
gallon of mix left in the hopper. When the MIX LOW
message is displayed, refill hopper immediately.
NOTE
Failure to refill hopper immediately may result in
operational problems.
G.
Menu Navigation Buttons
The Menu Navigation Buttons are primarily used
for machine calibration.
Selection Button (SEL)
The SEL button is not
functional in the normal operation mode. This
button is only used by service technicians for
machine calibration.
Set Button (SET)
The SET button is not functional
in the normal operation mode. This button is
only used by service technicians for machine
calibration.
Left Arrow Button (
)
Pressing any button on the
control panel automatically illuminates the display.
The backlight turns off several seconds after use.
To keep the display constantly lit, press and hold
the left (
) button for five seconds. The backlight
function can be reset to normal operation in the
same manner.
Up Arrow Button (
)
The
button is not
functional in the normal operation mode. This
button is only used by service technicians for
machine calibration.
H.
Front Door Safety Switch
The front door safety switch prevents the auger
from turning when the front door is removed. The
switch is open when the door is not in place and
closed when the door is properly installed.
Figure 3-2 IntelliTec Control
Push to Freeze
Green LED
Amber LED
SEL Button
SET Button
Purge/Clean
Button
Up Arrow Button
Left Arrow Button
