12
DC Powered Switch:
Power is supplied through an external
DC power source. Check the technical specification section for
information about the DC power input voltage.
Since the switch does not include a power switch, plugging its
power adapter into a power outlet will immediately power it on.
To the upper right of the power block is the ground wire
connection screw, and below the power block is the DIP-
switch control panel.
The plastic green contact
power block (shown at the top
of the diagram on the left) is
composed of six contact pins
and can be inserted and
removed easily by hand to
connect to the six-pin terminal
block receptor (male contacts
located on the body of the
Switch). The top two contacts
(PWR) are designated for the
primary DC input, while the
middle two contacts (RPS) are
for redundant DC input. The
lower two contacts (ALM) are
for connection to an external
alarm.
