Note
♦
Note installation position of battery.
♦
Use only the same type of 3-volt battery.
♦
Allocation of the remote control to the auxiliary/supplementary
heater remains intact. Re-adapting is not necessary.
– Release battery compartment cover -1- using a removal
wedge - 3409- .
– Remove battery.
– Insert new battery and refit cover.
Indicator lamp in remote control
Once you have pressed a button, the indicator in the remote con‐
trol -1- indicates whether the signal from the remote control has
been received by the auxiliary/supplementary heater and whether
the battery in the remote control is low.
Display -1-
Meaning
LED lights up green for 2 sec‐
onds
The auxiliary/supplementary
heater has been switched on
with button -3-.
LED lights up red for 2 seconds The auxiliary/supplementary
heater has been switched off
with -2- “OFF”.
LED slowly flashes green for 2
seconds
The signal to switch on was not
received.
LED quickly flashes green for 2
seconds
The auxiliary/supplementary
heater is blocked, e.g. because
the fuel tank is nearly empty or
there is a fault in the auxiliary/
supplementary heater.
LED flashes red for 2 seconds The signal to switch off was not
received.
Lights up orange for 2 seconds,
then green or red
The battery charge is low, but
the switch on/switch off signal
was received.
Lights up orange for 2 seconds,
then flashes green or red
The battery charge is low and
the switch on/switch off signal
was not received.
Flashes orange for 5 seconds
The battery is dead and the
switch on/switch off signal was
not received.
LED does not light up
The battery is dead.
Transporter 2020 ➤
Auxiliary heater - Edition 04.2020
60
Rep. gr.82 - Supplementary heating
