– Press button -3-.
• Warning lamp -2- must light up red.
The auxiliary heater switches to run-on mode and then switches
off.
Renewing remote control battery
Note
♦
Note installation position of battery.
♦
Use only the same type of 3-volt battery.
– Turn battery compartment cover -1- in -direction of arrow-.
– Remove battery.
– Insert new batteries.
– Close cover again.
Indicator lamp in remote control
Once you have pressed a button, the indicator in the remote con‐
trol -2- indicates whether the signal from the remote control has
been received by the auxiliary/supplementary heater and whether
the battery in the remote control is low.
Display -2-
Meaning
LED lights up green for 2 sec‐
onds
The auxiliary heater has been
switched on with -1- “ON”.
LED lights up red for 2 seconds The auxiliary heater has been
switched off with -3- “OFF”.
LED slowly flashes green for 2
seconds
The signal to switch on was not
received.
LED quickly flashes green for 2
seconds
The auxiliary/supplementary
heater is blocked, e.g. because
the fuel tank is nearly empty or
there is a fault in the auxiliary/
supplementary heater.
LED flashes red for 2 seconds The signal to switch off was not
received.
Lights up orange for 2 seconds,
then green or red
The battery charge is low, but
the switch on/switch off signal
was received.
Lights up orange for 2 seconds,
then flashes green or red
The battery charge is low and
the switch on/switch off signal
was not received.
Flashes orange for 5 seconds The battery is dead and the
switch on/switch off signal was
not received.
LED does not light up
The battery is dead.
Vehicles from week 22/2016
Transporter 2016 ➤
Auxiliary heater - Edition 04.2020
34
Rep. gr.82 - Supplementary heating
