Enabling and disabling displays
Use the
Settings
menu, submenu
MFI data
(Settings > MFI data) to enable displays you want to
be available under the MFI menu in the instrument cluster display. The units in which data is displayed
can also be changed
⇒
page 34.
Applicable only in Mexico, the AGCC, and South Korea
MFI
menu (Multi-Function Indicator): Premium version
¤
Please first read and note the introductory information and heed the WARNINGS
The MFI menu has two automatic trip memories:
1 – single trip memory
and
2 – total trip memory
.
The number of the memory is shown at the upper right of the display. The trip memories are in addi-
tion to the trip odometer, which is displayed in the bottom part of the instrument cluster and controlled
using the 0.0 / SET button on the right of the instrument panel
⇒
fig. 11
(7)
.
To display the distance driven on trips 1 and 2, select the
Route
item in the MFI menu (
MFI
>
Route
). Press the OK button (
⇒
fig. 15
) to toggle between Route 1 and Route 2 (trip 1 and trip 2).
Push and hold the OK button to manually reset a trip memory to zero.
1
Single trip
memory
The memory accumulates and stores information about distance driven and
fuel used from the time the ignition was switched on until the time it was
switched off.
If the ignition stays off for 2 hours or more, stored information is automatical-
ly deleted. If the trip is continued within 2 hours after the ignition was
switched off, the new values are added.
2
Total trip memory
The memory displays and stores the accumulated driving and fuel consump-
tion data of any number of single trips up to a total driving time of 99 hours
and 59 minutes, and up to a total distance of 9,999 km, depending on the
instrument cluster version. If one of the maximum values is exceeded, then
the memory is automatically cleared and starts again from 0.
Possible MFI menu displays
The following displays can be accessed in the MFI menu if enabled under
Settings
>
MFI data
.
Displays that are not enabled will not appear.
Display
Function
Travel time
Driving time in hours (h) and minutes (min) corresponding to trip memories 1
and 2 (toggle).
Consumption
--.- l/100 km
Current fuel consumption in miles per gallon (l/100 km) while driving.
When units are set to miles
, dashes appear instead of a number when the
engine is running and the vehicle is standing still.
When units are set to kilometers
, the display shows liters consumed per
hour when the engine is running and the vehicle is standing still.
Av. consumption
--.- l/100 km
Average fuel consumption in l/100 km on trips per trip memories 1 and 2
(toggle) is displayed once the vehicle has been driven about 100 m. Until
then, dashes appear instead of a number. The value displayed is updated
every 5 seconds.
Range
Estimated distance in km that the vehicle can go with the fuel left in the tank
the way you are currently driving. Takes account of the current fuel con-
sumption, among other things.
Route
Distance driven in km per trip memories 1 and 2 (toggle).
