Distributed by Volkswagen Zubehör GmbH Printed in Germany by Volkswagen Zubehör GmbH 14.09.2017 -19-
Figure 12
1. Unlock rotary knob (2) with key (6) if necessary.
2. Unscrew rotary knob (2) to open clamp (3) until clamp is
open to approx. hand width (A).
3. Press clamp (3) together and hold. Clamp (5) opens.
4. Position holder (4) in a suitable position on carrier
frame (1) and release clamp (3). Clamp (5) closes.
Figure 13
Note
Secure holder (2) only to bicycle frame, otherwise other items
of bicycle may be damaged. No other components such as
gear selector or brake cables may be clamped. Defective
holders must be replaced immediately.
1. Position holder (2) on bicycle frame and tighten clamp (3)
securely using rotary knob (1).
2. Lock holder (2) using key (4) and remove key (4).
3. Guide tensioning strap (6) centrally between two wheel
spokes and into buckle (7) then pull hand-tight.
4. Then use tensioning strap (6) tensioner (5) to fully tension
(arrow).
Note
Do not over tension the tensioning strap (6), otherwise the
tensioning strap (6) and/or the tyres/wheel rims may be
damaged.
The tension straps (6) are under tension when tightening.
The lock (8) may need to be forcibly depressed to release the
tension.
Note
The threads of the screws of the holder must be cleaned and
lubricated at regular intervals to prevent seizure of the rotary
knob.
Fitting second bicycle
Figure 14
The
¿
tting of the second bicycle is basically similar to the
¿
rst bicycle. The opposed allocation of both bicycles must be
observed.
Note
Secure holder (1) only to bicycle frame, otherwise other items
of bicycle may be damaged. No other components such as
gear selector or brake cables may be clamped. Defective
holders must be replaced immediately.
The second bicycle is secured using the longer holder (1).
Removing bicycle
The loosening of the holders and the removal of the bicycles is
carried out in reverse order procedure to fitting.
12
14
13
GB
GB
