1. SUPPLIED
1. 22 litre tank with 3-way valve
2. electronic control box with 8 character LCD display
3. positive displacement peristaltic pump (150 - 7500 ml/h)
4. electronic low level indicator
5. stainless steel nozzle with quick connector
6. 10 metres braided PVC tubing (int. Ø ¼ inch)
7. 7 metre electrical control box/pump connector cable
8. 1.5 metre power connector cable
2. INSTALLATION
2.1 Tank/Pump
Position where it will be easily accessible for filling, draining off excess inoculant and cleaning. For instance it could be
attached to the platform railings or to the side of the harvester behind the driver’s cab.
It should not be mounted inside
any of the harvester compartments where elevated temperatures would be detrimental to the survival of the
inoculant bacteria.
2.2 Control Box
Attach to a convenient point inside the harvester cab using the fixing bracket supplied.
2.3 Nozzle
The nozzle should be placed in the lower side of the chute, approximately midway along its length,
eg fit into the centre of a convenient cleaning flap. Drill a 14mm diameter hole in the centre of the
flap and screw the nozzle in place, pointing up the chute once the flap is re-attached.
3. ELECTRICAL CONNECTIONS
1.
All connections are via quick connectors
(to couple the electrical quick connector, line up the notch inside one end
with the gap in the other end then screw the two parts together tightly using the two dimpled nuts, screwing them in
opposite directions).
2. Connect the pump to the control box using the long connecting cable
3. Connect the control box to the power source
For a harvester with a table sensor -
connect the control box directly to the power source according to the wiring
colours shown below.
For a harvester without a table sensor -
either cut off the grey wire or attach it to the positive or negative (GND)
terminal.
-2-
Power Source
Positive (+ve) BROWN
Negative (-ve or GND) BLACK
Table Sensor (+ve) GREY
Control
Box
Pump
