Page 6
Kryo
Series Power Amplifiers
acoustics
1
1
1
1
2
2
2
3
4
4
5
Rear Panel
1.
Input XLR's
The input impedance of the balanced XLR's is 20K
Ω
. Pin 2 is
2.
Link / Dual Switch
Used to link one input to an adjacent input. In dual mode each channel uses
its own independent input.
3.
Gain Selection Switch
The three position switches select either 26, 32 or 38dB of gain per channel.
The default setting is 32dB.
4.
Configuration Switch
Each channels dip switches are used to set the Hi Pass filter, ICL clip limiter
and bridge mode. See page 7 for a detailed explanation.
5.
Output Speakons
In dual or link modes connect to
pins +1 and -1 on each individual output.
Out A/B is also wired so that channel A outputs on pins +1, -1 and channel B
outputs on pins +2, -2. The same applies to out C/D, where channel C outputs
on pins +1, -1 and channel D outputs on pins +2, -2. In bridge mode use out
A/B for one of the bridge outputs and connect to pins +1, +2 and use out C/D
for the other bridge output and connect to pins +1, +2.