VoiceCollect GmbH
Page 37
Voice
Collect
®
Technical Manual
SW Update okay . .
HW Reset
Z 11/08/09 11:25:16*
Tab. 39, IR44CF II display
– SW update okay message
The IR44CF II will start with the new software version without any further user interaction.
RESULT
: You have performed the IR44CF II software update from CF card using
the configuration menu of the IR44CF II.
TIP:
If a hardware address (serial number) is requested after installation, follow
chapter 5.2.2
„Entering the hardware address“ (below)”.
TIP:
If a hardware address (serial number) is requested after installation, follow
chapter 5.2.2
„Entering the hardware address“ (below)”.
5.2.2 Entering the hardware address
TIP:
The last 5 digits of the serial number (SN) are required to build the unique
hardware address (MAC) of the IR44CF II. The input of these digits may be re-
quested by the IR44CF II after a software upgrade.
The prompt to enter the serial number appears after the first software installation on the
IR44CF II display.
The reason for this is that the IR44CF II builds up a device-specific MAC address from the last 5
digits of the serial number and an internal IR44CF II device code.
The serial number can be found on the identification label on the back of the device.
Figure 14, IR44CF II
– Identification label