VoiceCollect IR44CF-II, Technical Manual

Page: 34 / 38

VoiceCollect GmbH Page 34
Voice Collect
®
Technical Manual
5.1.1 Hardware requirements
The following hardware requirements must be met to use the IR44CF WEBAccess software:

Processor CORE i3 or higher

Main memory 1 GB RAM or more

Hard disk 4 GB or more free hard disk memory

TCP/IP network link to the recorders

Operating system Microsoft Windows 7 (other Windows versions after consultation).
5.1.2 Installation
To install the IR44CF WEBAccess software on your PC, follow the procedure described into the
WEBAccess Installation and Configuration Manual. Please, ask VOICECOLLECT GMBH Ser-
vice Department to provide it.
RESULT: You installed the IR44CF II WEBA
CCESS
software.
5.2 Managing IR44CF II Software Update
CAUTION Device error due to power loss
If the power gets lost during a software update there will be nothing on the
display after a restart (device does not start). The IR44CF II must be sent to
the VOICECOLLECT GMBH customer service for repair.
Do not power-off the IR44CF II during the software update!
PREREQUISITE : Do not record during the software update. Set the Channel Trig-
ger to manual control before updating the software.
PREREQUISITE : Make sure the mainboard jumper P15, PIN 2-3 is set. If P15 PIN
2-3 is open, no software update will take place. Instead the IR44CF II initial software
will be loaded from the internal flash memory (basic software version).
See chapter 5: “Hardware”, paragraph “Jumpers” in this manual.
TIP: Note down all device settings (IP address, user application, start condition etc.)
before you start the update.
You receive new software for your IR44CF II in the form of two files: ldr.bin and ir44cf.bin . The
update files can be placed on the CF card or on the IR44CF PC.
There are two start options for the update if the update files are on the CF card: