VOH SA
GU-04-06-01
PAViX - User Guide
Version 3.2
Created 10.2017
Page 8 / 48
4.2.1 Entering family names and programs
On the home screen, select the navigation icon then press the "+" icon in the left column.
Figure 8
: Home screen with navigation icon / Home screen with “+” icon / Creating a calibre
4.2.2 Recording a working reference
It is required, for each created program, to define a height reference for the part-holder movement assembly.
This reference is done using a defined cleat.
The user defines a point on the part-holder that will be used for the reference as well as the height. It is
recommended to set this reference on the hour hand’s hour-wheel or on the minute-wheel.
The user selects the tool position. The cleat number is automatically populated, on the basis of the information
entered in the barrel configuration.
In order to compensate a potential flexion in the movement, the strength of reference “0” can be set to 5 - 20 N.
Figure 9: Selecting the parameters to record the working-program reference
4.2.3 Editing the program
Once the working reference is recorded, the user can enable the stages of the sequence required to set the
hands. A program allows for the setting of up to 14 different hands. Each stage has the following settings:
-
Tolerance of min and max force (mandatory)
-
Stop height (mandatory)
-
Barrel position (mandatory)
-
Type of hands set (optional)
4.2.3.1 Programming by learning (ONLINE mode)
Height teaching is carried out with the wheel stop. The height is displayed in real-time and saved using the
“SET” button. To change force, cleat no. and hand type settings, simply select the field concerned.
NOTE: To adjust the height, the position of the barrel on the staking-tool must match that of the selected
operation. If the position of the barrel does not match that of the selected operation, the height is displayed in
red and cannot be changed.
4.2.3.2 Programming by theoretical values (OFFLINE mode)
Height values are determined on the basis of a plan and are manually entered on the hand’s detail page.
Note: All height values can be changed OFFLINE by 0.01mm increments and saved.
