13
OPERATING INSTRUCTIONS
CAUTION: HOUSE FIRE HAZARDS
•
DO NOT STORE WOOD ON FLOOR PROTECTOR, UNDERNEATH STOVEPIPE OR ANYWHERE WITHIN
MINIMUM CLEARANCES FROM COMBUSTIBLE SURFACES SPECIFIED FOR THIS STOVE.
•
OVERFIRING MAY CAUSE A HOUSE FIRE. YOU ARE OVERFIRING IF A UNIT OR CHIMNEY CONNECTOR
GLOWS RED.
WARNING: EXPLOSION HAZARD
•
NEVER USE CHEMICALS, GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER
FLUID, OR SIMILAR FLAMMABLE LIQUIDS TO START OR “FRESHEN-UP” A FIRE IN THE STOVE.
•
K E E P A L L F L A M M A B L E L I Q U I D S , ESPECIALLY GASOLINE, OUT OF THE VICINITY OF THE
STOVE— WHETHER IN USE OR IN STORAGE.
OPERATING SAFETY PRECAUTIONS
1. NEVER OVERFIRE THIS STOVE BY BUILDING EXCESSIVELY HOT FIRES AS A HOUSE/ BUILDING FIRE MAY
RESULT. YOU ARE OVERFIRING THE STOVE IF UNIT OR STOVEPIPE BEGINS TO GLOW OR TURN RED.
2. NEVER BUILD EXTREMELY LARGE FIRES IN THIS TYPE OF STOVE AS DAMAGE TO THE STOVE OR SMOKE
LEAKAGE MAY RESULT
3. DO NOT BUILD FIRE TOO CLOSE TO GLASS.
4. UNIT IS HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING, AND FURNITURE AWAY. CONTACT MAY
CAUSE SKIN BURNS. DO NOT TOUCH THE STOVE AFTER FIRING UNTIL IT HAS COOLED.
5. PROVIDE AIR INTO THE ROOM FOR PROPER COMBUSTION.
6. INSPECT STOVEPIPE EVERY 60 DAYS. REPLACE IMMEDIATELY IF STOVEPIPE IS RUSTING OR LEAKING
SMOKE INTO THE ROOM.
7. ATTEMPTS TO ACHIEVE HEAT OUTPUT RATES THAT EXCEED HEATER DESIGN SPECIFICATIONS CAN RESULT
IN PERMANENT DAMAGE TO THE HEATER.
THIS STOVE IS DESIGNED TO BURN NATURAL WOOD FUEL ONLY!
Hardwood, 18”/46cm to 26”/66cm must be air dried (seasoned) for a minimum of 6 months. Logs greater than 6”/152mm
in diameter should be split. Wood should be stored in a dry, well ventilated area. The humidity content for usable
fi
rewood
must be less than 20% of the weight of the log. This heater is designed to burn wood only. Higher ef
fi
ciencies and lower
emissions generally result when burning air dried seasoned hardwoods, as compared to softwoods or to green or freshly
cut hardwoods.
Attempts to use wet or unseasoned wood will cause:
- ignition problems
- rapid creosote build-up resulting in chimney
fi
re
- incomplete combustion
- low heat yield
- blackened glass
DO NOT BURN:
1. Garbage;
2. Lawn clippings or yard waste;
3. Materials containing rubber, including tires;
4. Materials containing plastic;
5. Waste petroleum products, paints or paint thinners, or
asphalt products;
6. Materials containing asbestos;
7. Construction or demolition debris;
8. Railroad ties or pressure-treated wood;
9. Manure or animal remains;
10. Salt water driftwood or other previously salt water satu-
rated materials;
11. Unseasoned wood; or
12. Paper products, cardboard, plywood, or particleboard.
The prohibition against burning these materials does
not prohibit the use of
fi
re starters made from paper,
cardboard, saw dust, wax and similar substances
for the purpose of starting a
fi
re in an affected wood
heater.
Burning these materials may result in release of toxic fumes or render the heater ineffective and cause smoke.
Dead wood lying on the forest
fl
oor should be considered wet, and requires full seasoning time. Standing dead wood can
usually be considered to be about 2/3 seasoned. Splitting and stacking wood before it is stored accelerates drying time.
Storing wood on an elevated surface from the ground and under a cover or covered area from rain or snow also acceler-
ates drying time. A good indicator if wood is ready to burn is to check the piece ends. If there are cracks radiating in all
directions from the center then the wood should be dry enough to burn. If your wood sizzles in the
fi
re, even though the
surface is dry, it may not be fully cured, and should be seasoned longer