© Vocas Systems B.V.
13
To program the zoom-
focus link, it’s important to understand the meaning of the
“ST” (Start) and END-point. At “ST” the focus starts to move and at “END” the
focus stops it movement.
So both the Start- and the End-point on the focus-
and
zoom axis are directly
related to each other.
Be advised that the Start and End-points on the zoom- and focus axis are only
bound between WIDE and TELE respectively MOD and ∞. But the location of the
points is up to you.
To setup the Zoom-focus link, use the following procedure. After setting the mode-
switch to ZFL;
The message "ST" is shown in the display indicating that you are about to
program the start-point.
Zoom to the required zoom position and set its corresponding focus point by
using the zoom- and focus demand.
Push the set-key. In the display "END" is shown to indicate that the next point
is the END-point
Adjust the END-position of the zoom and set its corresponding focus-point.
Push the set-key again, as an indication that the link is active, "ACT" will be
shown in the display.
From this moment on the Z
i
F-100 will continually check either the zoom has
reached the start-point as you adjusted in the first step. If so, from that point on the
focus will move linear to the zoom towards the end-point you adjusted. The speed
of this focus-movement is done in relation to the zoom-speed. So when you stop
zooming the focus will stop as well.
After crossing the END-point the display will show "FIN" to indicate that the link has
reached it’s end.
By pushing the set-key once the program will be repeated. By continually pushing
the set-
key, the “CL”-message will appear to indicate that the program is cleared.
