VM Audio VAS310P Shaker Series, Install Manual

Page: 8 / 13

14 15
Loudspeaker Configurations Tips
Speaker Wires
When running long lengths of speaker wires, it is
recommended that higher gauge wire (12 Ga or higher) is
always used. Using speaker wires lower than 12 Ga limits
the amplifier from delivering full power to the loudspeaker(s),
which may result in poor sound performance.
Speaker Power Requirements
The following guidelines will assist you in selecting the
appropriate amplifier for your loudspeaker(s) to maintain a
safe level of operation.
• For clear, high quality performances where distortion
should be at its minimum, the loudspeaker(s) should be
powered with an amplifier capable of delivering twice its
power rating. (ex. Classical, Jazz, Instrumental, etc)
• For non-distorted high output performances where the
music is at a constant beat, the loudspeaker(s) should be
powered with an amplifier with the same power rating.
• For musical performances where distorted material will
be allowed to be played back, an amplifier with half the
power rating is recommended for safe operation.
Equipment Protection
• Always optimize the signal levels throughout the system
to avoid overdriving your system and the loudspeaker(s).
• When possible, use a low pass electronic crossover to
protect the loudspeakers from low frequency notes and
protect the system.
• Keep in mind the electrical limitations of your system.
• Always avoid feedback.
Single Loudspeaker Operation
Stereo Operation
CH 1
CH 2
CH 2 CH 1
Left Right