Eccellenza Pod
Operation Manual
28
Presets
This option allows you to select one of the preset configurations to be used on the machine. You can also
reset the machine to the original factory default settings from this menu (all settings), or just reset the
water pump calibration to the original factory setting.
To select one of the presets,
1. Enter the Set-Up mode and scroll to the Options menu and press the
Enter (
)
button.
2. Select the ‘
Presets
’ option and press the
Enter (
)
button.
3. Select the desired preset (1-3) and press the
Enter (
)
button.
a. Preset 1 = 6-oz, 8-oz, 10-oz
b. Preset 2 = 7-oz, 8-oz, 9-oz
(this is the default Factory Preset)
c. Preset 3 = 8-oz, 10-oz, 12-oz
4. Using the main power switch at the rear of the machine, switch the power OFF for ten seconds,
and then switch it back ON again. The selected ‘
preset’
settings are now loaded.
To reset the machine settings to the factory default settings,
1. Enter the Set-Up mode and scroll to the Options menu and press the Enter
(
)
button.
2. Select the ‘
Reset to Default
’ option.
3. To reset, press the Enter
(
)
button.
4. The lower line of the LCD will now display “
Reset to Default OK
” acknowledging that this option
has been initialized.
5. Press the “
Set-Up
” button to exit the set-up mode. After approximately five seconds, the machine
will reboot automatically with the factory default settings loaded.
NOTE: This same procedure also applies when selecting the "Restore Pump Calib." menu to restore the
water pump to its original factory setting.
