ViziT VIZIT-M441M, Operating Instruction, Page: 9 / 11

SETUP
Turn on the power supply unit or Commutator BKM.
Note.
Select a device (doorstation, or outdoor camera and door bell button) to make settings
Select a ring tone, set its volume*, adjust brightness, contrast and saturation of colour image. Set the
language, time and date, if needed
To select a setting
To set a ring tone RING SOUND MENU
MENU RING SOUND
To set a ring tone volume RING VOLUME MENU
MENU
RING VOLUME
To adjust image brightness, contrast and saturation MENU
MENU
Note.
To change menu language LANGUAGE MENU
To set date and time CLOCK MENU
MENU
MENU
OK MENU
CANCEL MENU
To quit menu OK MENU
Before turning the power on, make sure that there is no misconnection or risk of short circuit.
The Monitor’s Power LED (see Fig.1) illuminates with green light.
The Power LED may not illuminate at once, after turning the power on; the delay may take up to 7 seconds.
If in 7 seconds the Power LED is still dim, then the Monitor is in the sleep mode (calls are ignored, and all buttons
except for are disabled). To switch the Monitor on, push the button.
*Ring tone volume remains the same for both doorstations and door Bell Button, i.e. if you change ring tone volume for one
device, it will automatically change for the rest of connected devices.
, move the cursor bar up and down by pressing the and buttons.
(one of four), select ‘ ’ in the menu. the button, and the cursor bar jumps to the
current setting. or to select a new ring tone. Every time you press either or , the selected ring tone is
sounding. After you have chosen the ring tone, push the button. The cursor bar jumps back to ‘ ’.
(3 levels), select ‘ ’ in the menu. Push the button, and the cursor bar jumps
to the current setting. Push to decrease or to increase volume. Every time you push either or , the test sound is
ringing to present the volume level. After you have chosen the volume level, push the button. The cursor bar jumps
back to ‘ ’.
, select a corresponding line in the menu. Push the button,
and image from the selected device appears in the screen. In the lower part of the screen an adjustment bar is displayed. Set
a preferred value with the
or buttons and push the button to return back to the main page.
If the buttons and are not pushed within about 15 seconds, the monitor automatically quits the menu.
, select ‘ ’ and push the button.
, select ‘ ’ in the menu and push the button. The menu goes to the next page:
Select a required line with or , and push the button, the cursor bar jumps to the current setting. Change the
settings with or , and push the button. The cursor bar returns to the
To save settings and return to the main page of the menu, select ‘ ’ and push the button.
To return to the main page without saving setting, select ‘ ’ and push .
, select ‘ ’ and push the button.
·
·
·
1.
2.
3.
.
To select the doorstation connected directly to the Monitor, push the button.
The screen is showing image from the doorstation camera.
To select the doorstation and outdoor camera connected through the Commutator BKM, push the button
repeatedly until the screen shows image from the required device.
To select the outdoor camera with Door Bell button, push , and then .
The screen is showing image from the outdoor camera.
Having selected the device, push the button. The main page of on-screen menu appears on the screen.
Push
Push
MENU
menu line.
MENU
OK
Ring volume
Brightness
Contrast
Saturation
Clock
Ring sound
1
3
08
09
10
Language Eng
Cursor bar
Current
settings
www. 2016-02) /1 vizit-group.com VIZIT-M441M Operating Instruction (revision 9 1
Clock
Cancel
Year
Month
Date
Hours
Minutes
OK 11
10
21
10
30
Current
Settings