VIVOTEK
User's Manual - 175
66
far
Focus on further distance.
near
Focus on closer distance.
iris
auto
Let the Network Camera control iris size.
open
Manually control the iris for bigger size.
close
Manually control the iris for smaller size.
speedlink
0 ~ 4
Issue speed link command.
gaptime
0~32768
The gaptime between two consecutive ptz commands for
device. (unit: ms)
return
<return page>
Redirect to the page
<return page>
after the parameter is
assigned
.
The
<return page>
can be a full URL path or
relative path according to the current path. If you omit this
parameter, it will redirect to an empty page.
8.10 ePTZ Camera Control (capability.eptz > 0)
Note:
This request requires camctrl privileges.
Method:
GET/POST
Syntax:
http://<
servername
>/cgi-bin/camctrl/eCamCtrl.cgi?channel=<value>&stream=<value>
[&move=<value>] – Move home, up, down, left, right
[&auto=<value>] – Auto pan, patrol
[&zoom=<value>] – Zoom in, out
[&zooming=<value>&zs=<value>] – Zoom without stopping, used for joystick
[&vx=<value>&vy=<value>&vs=<value>] – Shift without stopping, used for joystick
[&x=<value>&y=<value>&videosize=<value>&resolution=<value>&stretch=<value>] – Click on
image
(Move the center of image to the coordination (x,y) based on resolution or videosize.)
[ [&speedpan=<value>][&speedtilt=<value>][&speedzoom=<value>][&speedapp=
<
value
>
] ] – Set
speeds
[&return=<return page>]
Example:
http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=0&move=right
http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=1&vx=2&vy=2&vz=2
http://myserver/cgi-bin/camctrl/eCamCtrl.cgi?channel=0&stream=1&x=100&y=100&
videosize=640x480&resolution=640x480&stretch=0
