VIVOTEK
User's Manual - 9
Mounting the Network Camera - Ceiling or Wall Mount
1� Use the curved slots on the camera as a template to mark where holes will be drilled on
the ceiling� Drill two holes into the ceiling; and hammer in the plastic anchors�
2� Drill another hole if you want to route cables through the ceiling or wall�
3� Connect and route an Ethernet cable through the ceiling or wall�
4� Attach the Network Camera to the ceiling using two included screws�
1
2
3
4
NOTE:
1� Do not completely tighten the mounting screws
in the screw slots yet� You may need to turn the
camera left or right for a best shooting direction
later�
2� The camera can only be powered by PoE� There
is no DC or AC input connector�
3� As shown on the left, you may also route cable
from the side�
Routing hole
position
LED Definitions
Item LED Status
Description
1 Steady
Red
Power on and system boot-
ing
Red
LED off
Power off
2 Steady
Red
+ blinking
Green
every 1 sec� (Green LED on
for 1 sec and off for another)
Network heartbeat
Steady
Red
+
Green
LED off
Network disconnected
3 Blinking
Red
every 0�15 sec� + Blinking
Green
every 1 sec�
(
Red
LED on for 0�15 sec� and
Green
LED on for 1 sec� and
off for another)
Upgrading firmware
4 Blinking
Red
every 0�15 sec� + blinking
Green
every 0�15
sec�
Restoring defaults
