User Manual rev. 1.2. Aug. 2015
278
5-2 Ping6
This section allows you to issue ICMPv6 PING packets to troubleshoot IPv6 connectivity
issues.
Web Interface
To configure an
ICMPv6 PING
Configuration in the web interface:
1. Specify ICMPv6 PING IP Address.
2. Specify ICMPv6 PING Size.
3. Click Start.
Figure 5-2: The ICMPv6 Ping
Parameter description:
IP Address :
The destination IP Address with IPv6
Ping Length :
The payload size of the ICMP packet. Values range from 2 bytes to 1452 bytes.
Ping Count :
The count of the ICMP packet. Values range from 1 time to 60 times.
Ping Interval :
The interval of the ICMP packet. Values range from 0 second to 30 seconds.
Egress Interface (Only for IPv6) :
The VLAN ID (VID) of the specific egress IPv6 interface which ICMP packet goes.
The given VID ranges from 1 to 4094 and will be effective only when the corresponding IPv6 interface
is valid.
When the egress interface is not given, PING6 finds the best match interface for destination.
Do not specify egress interface for loopback address.
Do specify egress interface for link-local or multicast address.
Start:
Click the
“Start” button then the switch will start to ping the device using ICMPv6 packet size
what set on the switch.
After you press , 5 ICMPv6 packets are transmitted, and the sequence number and roundtrip
time are displayed upon reception of a reply. The page refreshes automatically until responses
to all packets are received, or until a timeout occurs.
PING server 10.10.132.20
Summary of Contents for AW-GEV-264A Series
