>55mm
ø
10~11mm
B
Concrete wall mounting
Use anchor bolt
>55mm
ø
3mm
Wood
stud
wall
Not use anchor bolt
Loosen the screws with L3 allen wrench,
pull out the support arm around
4
'' (
100mm
)
and make power cable & signal cables go
through the support arm.
Pg.4
Take off the cap
Loosen the screw
D
The cables
The cables
The cables
C
F
The cables can be got through the wall plate
by three ways as shown in the pictures. Then,
Lock the screw “F” , but not tighten it
.
Note
:
You have to push the arm outward about
3mm before it can be installed.
●
The bracket is suitable for concrete wall mounting or wooden stud wall
or
calcium
silicate
board
(
screws
M6x55
●
Concrete wall mounting thickness must be a minimum 4''
,
Anchor bolt and screw (M6
x
55) are needed to be used for concrete wall installation.
●
ood
stud wall
and
gypsum
board
thickness
not
W
must be a minimum 20x12 inch, Stud thickness must be a minimum 3'' .
greater than 3/8 inch
If the wall is not strong enough reinforce it suf
fi
ciently before installation
.
●
Please contact
if you have any questions about mounting surface issue.
manufacturer
●
All of the fastening screws provided have to be used
。
●
Calcium
silicate
board
mounting
,
screws
M6x55 must
be
attached
to
the
stud
and
securely
fastened
.
s
c
rew (M6
×
55)
and anchor bolts
are needed
for
concrete wall mounting.
C
A
The arrows up
Only
s
c
rew (M6
×
55) are needed
for
wood
stud
wall or calcium silicate board mounting.
C
A
The arrows up
C
A
For
wood
stud or calcium
silicate board mounting,
screws M6x55 must be
attached onto the center of
stud and securely fastened.
The arrows up
Or
These four screws must be
fastened on the stud.
These two screws must be
fastened on the stud.
must
be
attached
to
the
stud
and
securely
fastened
。
